Industrial Level Control Division
Level controllers, switches and transmitters,
designed specifically for harsh industrial applications,
including caustic and chemical solutions for liquid and solid measurement.
|
Australian
Distributors of
WaterLOG® high precision environmental products for water & weather measurement.
|
WaterLOG® H-335
Precision Inclinometer With SDI-12 Output
Specifications
General
| Sensor: |
ceramic, single axis, linear, wide angle |
| Outputs: |
SDI-12 & 2-wire Quadrature |
| Type: |
electrolytic fluid |
| Range: |
-40o to +40o (80o total |
| Resolution: |
.005o |
| Accuracy: |
±0.03o (absolute over full range) |
| |
(0.25" gate height with 36' gate radius) |
| |
(0.13" gate height with 20' gate radius) |
| Offset Adjust: |
software command with gate against sill |
| Temperature: |
-30o to +50oC (calibrated range) |
| Settling Time: |
<300ms |
| SDI-12 Measurement Time: |
2 seconds |
SDI-12 Output
| Baud Rate: |
1200 |
| Protocol: |
SDI-12, 7-bit even parity, 1 stop bit. |
| Output Voltage Levels: |
|
| minimum high level: |
3.5 volts |
| maximum low level: |
0.8 volts |
| maximum cable length: |
250 ft. |
| SDI-12 Output Data Parameters: |
|
| 1: Gate Arc Length (feet, inches, metres, etc..) |
|
| 2: Gate Height (feet, inches, metres, etc..) |
|
| 3: Gate Angle (degrees) |
|
| 4: Temperature (oC) |
|
Power Requirements
| Voltage Input: |
10.0 to 16.0 Volts DC |
| Current: |
|
| Measuring: |
30 mA |
| Standby: |
20 mA typical |
Environmental
| Operating Temperature: |
-30 to +60oC |
| Storage Temperature: |
-50 to +70oC |
Mechanical
| Material: |
40% graphite filled fibreglass |
| Size: |
4.76" x 4.76" x 2.5" high |
| Rating: |
NEMA 4X, 6 |
| Connector: |
liquid tight starin relief fitting .08" to .24" dia cable |
| Beam Clamp: |
2" max I-beam thickness |
| Shaft Clearance: |
1.75" |
| Cable: |
not included |
| Recommended Cable: |
polyurethane or similar, rated for water immersion and sunlight resistance |
H-335 mounted on a steel I-beam
Warranty
WaterLOG® H-335 is warranted against defects in materials and workmanship for one year from date of shipment.
Note
Specifications subject to change without prior notice due to on going commitment to product testing and improvement.
September 1, 2000
WaterLOG® H-335 Introduction
WaterLOG® H-335 Specifications
Download PDF File (268kb)
|
H-335 Introduction
Specifications
Download PDF File (268kb)
|
