Semrad  
        Australian distributors of environmental management products for water resources

Semrad ~ Environmental products water management

On Line Catalogue ~ Water data collection platforms, sensors, transmitters and systems

Contact Semrad ~ Australian Distributors of Environmental management products

About Semrad ~ Australian distributor for water measurement, control, management products

Distributor Area


Industrial Level Control Division

Level controllers, switches and transmitters, designed specifically for harsh industrial applications, including caustic and chemical solutions for liquid and solid measurement.


Australian
Distributors of


Australian distributor of Waterlog environmental management products

WaterLOG® high precision environmental products for water & weather measurement.
*
WaterLOG® H-330
Dual Interface Shaft Encoder with SDI-12 & Quadrature
Specifications


Waterlog H-330 diagram

General
Input: Shaft Position
Outputs: SDI-12 & 2-wire Quadrature
Resolution (SDI): 200 counts/rev
Resolution (Quadrature): 100 counts/rev
Max Shaft Rotation: 15 rev/sec

Quadrature Output
Type: Open Drain (optional factory installed pull up resistor to 5.0 V)
Transient Protection: 5.0 V Transguard

SDI-12 Output
Baud Rate: 1200
Protocol: SDI-12, 7-bit even parity, 1 stop bit.
Output Voltage Levels:  
   minimum high level: 3.5 volts
   maximum low level: 0.8 volts
   maximum cable length: 250 ft.

Power Requirements
Voltage Input: 9.6 to 16.0 Volts DC
Current: Less than 2.0mA, 800uA typical

Environmental
Operating Temperature: -40 to 60oC
Storage Temperature: -50 to 70oC
Humidity: 0 to 100%oC

Mechanical
Bearing: Double bearing with external seal and .125" separation
Starting Torque: 0.15 oz-in typical
  0.50 oz-in max over temperature
Shaft Length: 2.00"
Shaft Clearance: 1.75"
Shaft Thread: 24 threads/inch
Thread Length: 0.75"
Material: Anodised Aluminium
Size: 5-1/8" wide (main unit)
  7" wide (base plate)
  4-1/4" high
  4" deep (not including shaft or connectors)

Connectors (2 ea, same connections)
H-330: AMP 206486-1 (9-pin male)
Cable: AMP 206485-1 (9-pin female)
  One cable supplied with H-330

Warranty
WaterLOG® H-330 is warranted against defects in materials and workmanship for one year from date of shipment.

Note
Specifications subject to change without prior notice due to on going commitment to product testing and improvement.
September 1, 2000

WaterLOG® H-330 Introduction
WaterLOG® H-330 Specifications
Download PDF File (249kb)
Water quality, water, quantity and water control

H-330 Introduction
Specifications
Download PDF File (249kb)

Australian water resources preservation




To Top of Page
To top of page


Home | Catalogue | Contact | About Us | Distributors

Environmental Management Products for Water measurement

© 2002 Semrad Pty Ltd Australian Distributors of
Environmental products - high precision instruments, data logging & communications
for effective water level measurement, flow control and environment management.


Water management equipment Australian distributors